![]() Select a base station, and then, while holding down the option key, click on Edit.You can do this easily from the AirPort Utility, as follows: To determine which base station the wireless client is connected to you would just need to know this ID.įirst you will need to know what they are for each of your base stations. Each base station has a unique ID, called the BSSID. is there a way to time which Airport our devices are pulling the wifi signal from? If successful, repeat the above steps for the third base station.At this point, verify that you can gain Internet access from either base station.When you get the "Setup Complete" message, click on Done.This is what you want for a roaming type network. This is telling you that the AirPort Utility has determined that you will be extending using an Ethernet connection between the base stations. The next screen should have the title: Setting up this AirPort Extreme to extend "" using Ethernet.I suggest using a name that uses 16 alphanumeric characters or less and does not include either spaces or special characters. Enter a base station name for the extending base station, and then, click on Next.Click on the base station in the menu and the AirPort Utility should start up.The extending base station should now show up under the title: New AirPort Base Station in the Wi-Fi's dropdown menu. On your Mac, click the Wi-Fi icon on the macOS menu bar.Connect one of the extending base stations using an Ethernet cable between one of the available LAN (opposing arrows) ports of the main to the WAN (circle-of-dots) port of the extending station.Once done, verify that you can access the Internet successfully. Using the AirPort Utility configure the main base station as required. ![]() Keep all of the base stations in the same location for ease of setup. Leave all but the "main" base station powered-off and disconnected from the network. Perform a "factory default" reset on each of the base stations.To make the setup easier, I would suggest the following: Each base station will broadcast their own Wi-Fi network, but use the same Network Name, wireless security type & password, so that wireless clients will "see" them as a "single" network.This can be accomplished via Ethernet switches or Power-line adapters as required. Each "extending" base station must be connected back to the "main" base station by Ethernet.What you are trying to set up should work just fine. Unfortunately, the link I provided you is seriously out-of-date and Apple has yet to edit it for the newer version of the AirPort Utility. What you appear to be trying to set up is a roaming network with your three AirPort Extreme base stations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |